This tip is very easily damaged and should NEVER be touched with fingers, tissues, or anything else. Minimizing Pulsations Ari Mist Nebulizers will pulse if the pump can not deliver constant sample flow: Change your pump tubing often, or use a surgeless pump if possible or a Syringe Pump or Gravity feed.ĭO NOT TOUCH THE TIP! The gas orifice at the tip of the nebulizer is Peek, and is SOFT. To achieve low flow, the operating pressures should be higher, in the range of 55 - 90 psi. Note: Burgener Ari Mist HP Nebulizers require 75 - 90 psi to have a 1 liter per minute of Argon gas flow, so the operating pressures are in the range of 40 - 70 psi, depending on the torch optimum flow rate. Note: Burgener Ari Mist Nebulizers require 45 - 55 psi to have a 1 liter per minute of Argon gas flow, so the operating pressures are in the range of 35 - 45 psi, depending on the torch optimum flow rate. If in doubt about correct operating procedures, call an experienced operator or call Burgener Research at +1 9. This device operates on compressed gases. ![]() Acids, particularly HF, often look like water and will wet the end of the nebulizer during usage. Use at your own risk.ĭo Not Handle unless you are sure that the nebulizer is dry, or washed with clean water. The manufacturer assumes NO liability for damage however caused in the handling & usage of the nebulizers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |